I would say about one and a half to two rounds, per gold, silver or copper piece... By D&D coin weight and the listings in the RCS books, the ratio of coins to pounds, is 50 coins to 1lb. But the listing for ammo for muskets and pistols is 10 shots for 2lbs. This seems unrealistic in weight to me a bit. Even for lead.
Now considering the shot is lead but small, then you can probably lower the weight of such specialty shot by 1 to 1 1/2 pounds as well.
Of course if you wish to apply this adjusted weight to the shot then you might perhaps wish to know how this compares to the weight ratios of the precious metals...
50gp = 1lb so if you use standard weight of the shot which is two pounds gold bullets would cost 100 gp per 10 which is ridiculus. Now if the weight was lowered to say .5 of a lb for 10 shots then the amount would decrease by 75% thus making it 25 gp. Of course gold is lighter than lead so the shot would reflect this, so I would once more cut the weight of it in half. 12 gp total for 10 golden bullets at 0.25 lbs... Now this would also reflect to a slight extent the gold lost from the smelting process.
Of course once more you are making the bullets and not the direct value attached to them so if you where to lower the price any further I would only lower it by a maximum of say 4 gp or the equivilent peices since the weight/size of the coins is considered to be the same through out.
So a decent stat adjustment for such would I think be so...
Standard Lead shot: simply reduce weight to 0.5 pounds. Cost for materials will vary by dm or campaign for crafting.
Gold shot: 12 to 8 gp, 10 shots, 0.25 lbs
Silver shot: 12 to 8 sp, 10 shots, 0.25 lbs
Copper shot: 12 to 8 cp, 10 shots, 0.25 lbs
ect, ect, ect....
I would also suggest if using this method that you lower the lead shots weight to at least 1 lb. This is really not that big an issue as they also must carry powder for each shot and the gun it's self is heavier.
But as for if you wish to just plug in these suggestions then I would have to say just halve the weight of specialty shot to one pound and then give a price equal to 15 - 12 coins in materials. DC would probably be low but would require a smelting kit, a bullet mold or ball clamp, and of course an amount of the metal to be used. MW of course should cost perhaps slightly more but it seems hard to justify more than perhaps adding one coin per two spent if you are crafting such...
If sold than market price should probably just be about 1 1/2 to 2 times the coins used in the materials if that should come up. So the range of market price is probably 18 to 30 coins for such efforts, of the same value as the materials.
Hope this works for ya!
